The Tekonsha Prodigy P2 electric trailer brake controller is a small device with a big responsibility. As one of the most popular and most trusted brake controllers on the market, this proportional brake controller utilizes primary sensor technology to provide a smooth braking response in any stopping situation. The Prodigy P2 has an easy-to-use knob so you can effortlessly set the power output to your desired braking power, a boost feature that lets you apply up to three levels of additional braking power, especially when hauling heavier loads, the choice of electric or electric over hydraulic braking, and manual override to help you brake safely when an unexpected stop pops up. The P2 also has an LED digital display so you can monitor your settings and trailer braking activity and a power-save mode to reduce battery drain when not in use. This intuitive brake controller can easily be positioned on top of or under the dash, with your choice of a mounting bracket or mounting pocket and is self-leveling when mounted within a 90-degree vertical range, so theres no need to adjust the unit once its installed. When youre done towing, the P2s snap-in dash mounting clip, Plug & Play port for two plug adapters, and removeable electrical connector allow the unit to be quickly stored. The Prodigy P2 truly is a complete trailer brake controller kit. It works with trailers with 1-4 axles, comes with all the mounting hardware needed for installation, and is backed by a limited lifetime warranty.

Brake Controller Wiring

Tekonsha trailer brake controller harnesses exist to make connecting your brake controller to your vehicle as easy as possible. These custom two-plug units are specifically designed to be used with any Tekonsha brake controller. The Plug & Play feature on the Tekonsha wiring harnesses makes them easy to install. Simply plug one end of the harness into the back of your desired Tekonsha brake controller and the other end into the port in your vehicle. No cutting, splicing, or taping required. Each wiring harness is made up of four copper wires wrapped with a braided nylon thread to insulate the wires and protect them against nicks, punctures, and elevated temperatures. The four-pin Plug & Play connectors on each end of the harness are uniquely designed, with one end to fit each vehicle based on make and model year specifications, while the other end plugs easily into any Tekonsha brake controller.